Board index Trinity Technical Discussion Trinity Dodge Gas Analog input information

Analog input information

Post questions about your Trinity for your Dodge/Jeep/Chrysler vehicles here.

Moderator: mikel

Post Tue Oct 27, 2009 12:26 pm

Posts: 55446
Location: DiabloSport World Headquarters

The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:

Image


To convert the slope/intercept, try the following:

low value = intercept
high value = intercept + ( 5 * slope )

I am going to sticky this thread for others.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Tue Jul 20, 2010 1:40 pm

Posts: 27
seems to match the output analog from the Innovate LM1.....

Post Thu Nov 25, 2010 11:07 pm
magmax

mikel wrote:
The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:

Image


To convert the slope/intercept, try the following:

low value = intercept
high value = intercept + ( 5 * slope )

I am going to sticky this thread for others.


could you elaborate more on how to convert low and high value ?

I got a 0 to 4 volt linear output from my autometer gauge, how do I
program the trinity to read an air fuel ratio instead of 0 to 4 volt reading ?


Return to Trinity Dodge Gas