Board index inTune i-1000 Technical Discussion inTune DCX (i-1000-DCX) Knock sensor voltage PID and DataViewer

Knock sensor voltage PID and DataViewer

Post questions/issues related to your inTune-DCX application here.
Post Fri Jan 15, 2016 10:20 am

Posts: 28
I can select knock sensor voltage at the Intune and record it. But I never saw the option to see that pid at DataV. Might be I just missed that ?
Its important for me as sometimes I saw voltage 4.99 V at idle at one or at two banks. Some times zero and zero with the same fuel and weather in tank. I can not understand why knocks are at idle. It should not be like so.

So wanted to see the logs after drive but I didn't found it via DV.

Thanks in advance


Posts: 53295
Location: DiabloSport World Headquarters

post the log...
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Posts: 28
mikel wrote:
post the log...


here you are
You do not have the required permissions to view the files attached to this post.


Posts: 53295
Location: DiabloSport World Headquarters

well, it is not in that log, try the restore default PID option in the logging menu and try it again.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Posts: 28
mikel wrote:
well, it is not in that log, try the restore default PID option in the logging menu and try it again.

Ok, I will post it later, thanks !


Return to inTune DCX (i-1000-DCX)