PCM Calibration Help please

[11Chally3.6]

Hello!

I just bought a I-1000 DCX and was trying to tune my 2011 Challenger 3.6

But every time i try to tune the Car it tells me a PCM Calibration update might be needed.
Hooked it up back to the PC, but Ignition is telling me the Device is up to date.

How do i get the PCM Cal. Update on my DCX?

I´ve read about issues with the Start Button on the Challenger, should I use the Key instead?



Any Help would be greatly appreciated.

Here´s the .xml File:

[11Chally3.6]

Fixed it!

When the Device says "PCM Cal. Update might be needed..." klick on yes and then immediately disconnect it and plug it into the PC.
Don't klick "continue" or it will reboot a couple of seconds and then go back to the start screen and afterwards doesn't start the needed Download in the Ignition updater once connected back to the PC.

After I disconnected as stated above, the necessary download was promptly found on Ignition and installed.
The Rest worked flawlessly from there....

I hope this helps anyone with the same Problem and sorry for my english, I'm from Germany....