Board index i2/i3 Technical discussion i2/i3 for Dodge, Chrysler, Jeep and Ram P0601 code after new calibration update

P0601 code after new calibration update

Post here with any questions specific to the use of the i2 on Chrysler vehicles.

Moderator: sohfast94


Posts: 15
mikel wrote:
OK, this one is fixed.
I should be able to do this all automatically.

1. return vehicle to stock/original backup
2. Update device, it should force it to do a calibration update
3. Go to vehicle and click tune menu and it should prompt to go back and check for an update.
4. Update again to download the new updated stock file
5. Load it to the vehicle through the tune menu, no more code.



couple minutes after starting up and idle it thru P0601


Posts: 56543
Location: DiabloSport World Headquarters

doesnt sound like it did the cal update.

Please give us a call with the device powered up in the truck and we'll force the cal update with you.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Posts: 15
no after the last update i tried to connect to wifi and not it freezes for a couple minute then it has blank list of wifi networks


Posts: 56543
Location: DiabloSport World Headquarters

theres a wifi bug were working on, please use a pc and update agent for now if possible.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Posts: 15
mikel wrote:
theres a wifi bug were working on, please use a pc and update agent for now if possible.


okay are you able to force cal update with it plugged into laptop and running update agent?


Posts: 56543
Location: DiabloSport World Headquarters

yes if you update now it should trigger the cal update.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Previous

Return to i2/i3 for Dodge, Chrysler, Jeep and Ram