Board index Trinity 2 T2 for Dodge/Chrysler/Jeep/Ram Trinity t2 after update shows not supported for this vehicle

Trinity t2 after update shows not supported for this vehicle

This area of the forum is for discussions relating to the T2 monitor/tuner on Chrysler vehicles.

Moderator: sohfast94


Posts: 3
After updating my Trinity t2 for my 2014 charger rt, now it says not supported for this vehicle. Very frustrating considering I have had it for like 4 months with no problems till new update. :crashing:


Posts: 1
My RAM Truck, 2016 PW 2500 6.4L, spent a tremendous amount of time in the last 24 and I end up with my truck no longer being supported. If the T2 was a little faster (a lot faster) data logging and PID selection would be possible but its barely tolerable. I'm not trying to be nasty or bashing because I use my T2 everyday. I love its functionality and even more so after the update. But holy gawd, it didn't get any faster.
Any way, speed is not my T2 problem, the problem is no support for my truck when I try to connect Dataviewer to my T2. I have gone back and reinstalled USB drivers, and checked for further updates.
If I need to start a new thread I can, I just figured the exact same error message

thanks for any help


Posts: 55016
Location: DiabloSport World Headquarters

miskonskarn wrote:
After updating my Trinity t2 for my 2014 charger rt, now it says not supported for this vehicle. Very frustrating considering I have had it for like 4 months with no problems till new update. :crashing:

Did you return to stock before updating?
if so update it again then try tuning, if it still gives a message to update post the current info.xml file please.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Return to T2 for Dodge/Chrysler/Jeep/Ram