Board index Trinity 2 Trinity MX monitor Temp Gauges

Temp Gauges

This section of the forum is for discussions relating to the Trinity MX line of monitor devices.

Moderator: sohfast94

Post Sat Jul 28, 2018 7:01 pm

Posts: 1
Hello just curious if Trinity 2 MX will display temp readings in particular Transmission Temp and Car oil Temp
Thanks in advance for info

Post Mon Jul 30, 2018 9:27 am

Posts: 53704
Location: DiabloSport World Headquarters

What vehicle?
Engine oil temp is not normally something the PCM monitors...
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Mon Jul 30, 2018 5:04 pm

Posts: 17279
Location: CT

And on GM vehicles, the tranny stuff is not and can not be monitored at all.. only the engine parameters/PID's can be monitored, nothing for the transmission..

Again, I'm talking about 2007+ GM vehicles... it may or may not be the same for Ford/Dodge/Chrysler/Jeep...
06MonteSS / DiabLew Tune
Image
2014 Camaro SS - 2SS, RS pkg., short-throw shifter, NPP perf. exhaust, BMR strut-tower brace, Cold Air Inductions cold air intake
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com -- www.diablocustomtuning.net

Post Wed Sep 12, 2018 2:32 pm

Posts: 8
A 2008 Pontiac GXP had a onboard info center that included transmission temperature. I guess that was through a temp sensor unable to be read by the ECM? Just curious. Actually all the LS4 GXPs had that.

Post Fri Sep 14, 2018 3:07 pm

Posts: 53704
Location: DiabloSport World Headquarters

Kytprice wrote:
A 2008 Pontiac GXP had a onboard info center that included transmission temperature. I guess that was through a temp sensor unable to be read by the ECM? Just curious. Actually all the LS4 GXPs had that.

Trans temp is different. PCM often monitors that for various reasons, and the PID can be sent from the TCM or PCM in different applications.
Engine oil temp is not often something the pcm is monitoring in all cases.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Fri Sep 14, 2018 6:39 pm

Posts: 8
Only interested in Transmission temp. Oil pressure and transfer temp. So unless I'm reading your reply wrong it can be done. If so can you send me a file to apply to my Trinity 2? Heat is what destroys these 4T65-HD transmissions. I have a cooler but would love to keep a eye on it.

Post Mon Sep 17, 2018 8:03 am

Posts: 53704
Location: DiabloSport World Headquarters

No, I dont mean to keep confusing things here.
TCM PIDs for GM are not something we can display on our devices at this time.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Return to Trinity MX monitor