Board index Trinity 2 Trinity MX monitor C to F

C to F

This section of the forum is for discussions relating to the Trinity MX line of monitor devices.

Moderator: sohfast94

Post Tue Jan 28, 2020 8:39 pm

Posts: 14
How do I change the units to read as F? The temp gauge has the range to 240, yet reads in C so its low.

Thanks

Post Tue Feb 04, 2020 12:43 pm

Posts: 14
Nobody?

Manual tells you how to change units and to change metric to imperial, but im not finding how to change off of Celsius.

Thanks

Post Tue Feb 04, 2020 1:21 pm

Posts: 55881
Location: DiabloSport World Headquarters

there should be a global option in settings or 2x click on any gauge and change it in the editor.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Tue Feb 04, 2020 5:01 pm

Posts: 14
Thanks for the response, i must be blind. Im not finding it. I agree there should be one lol.

For example I 2x on the IAT gauge, itll let me change the tic marks and range, but not finding the C to F.

Do you happen to have a menu breakdown sheet?

Thanks

Post Tue Feb 04, 2020 5:50 pm

Posts: 55881
Location: DiabloSport World Headquarters

go to settings and select 'unit of measure' and try changing it there.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Tue Feb 04, 2020 5:54 pm

Posts: 55881
Location: DiabloSport World Headquarters

to do a single gauge, 2x click it to open the editopr then at the bottom/middle o the screen there is a switch to go from Imperial to Metric for that single PID.


Thanks
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Wed Feb 05, 2020 12:23 am

Posts: 14
Yea , i did the Metric to imperial. It stays as Celsius in both. Thats how I assumed it was supposed to work.

Ill try again and restart it. Will report back. Thank you

Post Fri Feb 07, 2020 9:49 pm

Posts: 14
Ok so ive tried changing it through the settings, and through the gauge editor. Both changing to metric and back to imperial.. no change.

Im mainly looking at the ECT gauge. Has the tic marks to 240 but digital displays 80deg C

Don’t know what else to try. IATs are displayed in F

Thanks

Post Tue Feb 11, 2020 2:54 pm

Posts: 14
Beuller?


Return to Trinity MX monitor