Mafia throws a wrench code on my Mustang gt 2006

MAF.i.a Support

Moderator: mikel

Post Reply
ethrjock
Posts: 2
Joined: Wed Jun 03, 2009 9:01 pm

Mafia throws a wrench code on my Mustang gt 2006

Post by ethrjock »

This weekend at the track half way down the 1/4 my gt basically quit running.

In the pits the car would hardly hold idle sputtering with black smoke, rich etc. teh wrench code came up in the cars diagnostic center.

how we got the car running again was by disconnecting the mafia from the maf. the car would run and I limped home. the car would also run if I connected the maf directo the factory ford harness and bypassed the mafia.

It would seem that the mafia is defective in some way.

I can reconnect it to my wiring harness...what should the output voltage read?

Thanks
User avatar
mikel
Posts: 57766
Joined: Tue Jan 16, 2007 1:17 pm
Location: DiabloSport World Headquarters
Contact:

RE: Mafia throws a wrench code on my Mustang gt 2006

Post by mikel »

I dont have numbers off my head, but ideally it attenuates the voltage signal to the PCM, so it should be less with the Mafia than without it.
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST

tech@diablosport.com
Post Reply