Analog input information

[mikel]

The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:




To convert the slope/intercept, try the following:

low value = intercept
high value = intercept + ( 5 * slope )

I am going to sticky this thread for others.

[aarcuda72032]

seems to match the output analog from the Innovate LM1.....

[magmax]

The updated manual should be coming along soon. You need a 2.5 mm stereo plug, which is DigiKey part # CP-2501SP-ND. Wire it up as follows:




To convert the slope/intercept, try the following:

low value = intercept
high value = intercept + ( 5 * slope )

I am going to sticky this thread for others.

could you elaborate more on how to convert low and high value ?

I got a 0 to 4 volt linear output from my autometer gauge, how do I
program the trinity to read an air fuel ratio instead of 0 to 4 volt reading ?