Board index i2/i3 Technical discussion i2/i3 for Dodge, Chrysler, Jeep and Ram i3 won't finish update!!

i3 won't finish update!!

Post here with any questions specific to the use of the i2 on Chrysler vehicles.

Moderator: sohfast94

Post Tue Aug 13, 2019 2:57 am

Posts: 2
After checking for updates the device is saying that "Updates are available, would you like to download and install now?" Once I start the updating it cycles through to about 35% then starts over and cycles to 36% then starts over and cycles to 26% then it goes straight to the "Do you agree with these terms?" acknowledgement. After I click the green yes button the device locks up. I unplugged the device waited a few minutes then plugged it back in and went through the update process again and came up wit the same result. It seems the device is always saying there are updates but never finishes the update process. Any help would be greatly appreciated. Thanks.vidmate mobdro word counter
Last edited by mashagomes on Wed Aug 14, 2019 1:54 pm, edited 1 time in total.

Post Tue Aug 13, 2019 3:00 pm

Posts: 55821
Location: DiabloSport World Headquarters

please post the info.xml file from the device.

Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
M-F 8:00 AM to 5:00 PM EST

Post Sun Dec 29, 2019 6:48 am

Posts: 2
Was this resolved? Update directly over Mac seemed to have worked fine.

Return to i2/i3 for Dodge, Chrysler, Jeep and Ram