Mine also does this.

bump: Question: What % throttle is considered WOT?

So I sent back to the stock tune until I can do some more research. The knock values made me a little uncomfortable. Yes the stock tune knocks too, but it is less.

I did modify the stock tune by increasing the throttle boost by 20% and added 5% fuel (by going negative :? /to the left (richer) in ...

Gentlemen,

I have a question/suggestion:

Could you set up the "inTune Technical Discussion" forum the same way as the Trinity and the Predator forums with the individual sections? (Ford Gas, For Diesel, Dodge Gas, Dodge Diesel, GM Gas, GM Diesel)

Love the product (inTune) so far.

Mike,

So I have several years experience tuning my LT1 Procharged 91 S10 (ODB1) using Craig Moates set-up (Moates.net).

I am not yet looking to dig that deep into my Hemi Dakota, but is there a way to compare (side by side) the parameters of the tunes in the inTune for my set-up?

I would like to ...

Success!

It took two tries to install PCM update. First attempt was met with "an error occurred while trying to install update" and then it was in recovery mode.

Second attempt went through fine.

I installed the 87 Octane tune for now.

I appreciate you guys' assistance on this.

Comments:
In the ...

okee dokee

I really appreciate you working with me and I promise I am not trying to be difficult. I am just trying to understand the risk. To understand the risk, I need to explain everything to the experts (you) so you can convey the risk to me (if any). Maybe this conversation would have been better over the ...

So, if I load the PCM update from the tuner into the Ram PCM, I am at no risk of corrupting the update ("brick/paperweight" the PCM) because of the Dakota VIN that is currently in the Ram PCM?

When you say calibration ID (calid), are you referring to 56029166AF?

Reminder: it's my 2004 Dakota VIN that it is reading.

So is it using the Dakota VIN to determine what or how to tune or is it just using the PCM number?

Mike,

Thanks for the quick response. I know that for the donor Ram that the PCM version goes up to AI.

So by latest calibration, you are referring to updating from 56029166AF to 56029166AI or am I reading too deep into this?

What is your recommendation, should I pull the trigger on the PCM update ...

Background:
- I am running the 2004 Ram 1500 PCM and 5.7 Hemi Engine in my 2004 Dakota.

- Only issues I had on the install that I could not fix were VIN mismatch between the Ram Hemi PCM and my Dakota's ABS module and Stock Stereo System (and AC/Heater controls). To remedy these issues, the dealer ...