Decided to take a look at the PIDs on the Diablo Tune > very surprised to see up to ~5 degrees of KR on a stock motor using only the canned tune. I deleted the 93 octane tune and tried the 91 octane tune with similar results. The runs were from about 70mph (~4,000 rpm) to 120mph (~6,400 rpm) on an ...

Thanks!

Thank you for the response. If you already have the Diablo Tune installed, should you modify the backup and upload replacing the Diablo Tune or is it better to return to the OEM Tune and start from scratch?

Is it possible to only disable the DOD feature without installing one of the Diablo tunes?
Thanks

I also experienced a problem with the auto updates. The I2 would complete the Update but the GM file was not the latest file per the downloads page on the Diablo website. I deleted the group update file as previously suggested and the I2 updated again but with the same results. To solve the problem ...

Has the i1000 unit been updated since the 4/27/16 release? The trinity and i2 units have received new GM tunes on 5/30 and 5/27/16 respectively. I would like to try the i1000 but am concerned it does not have the lastest software updates. Thanks.

Mikel,
Is this new tune available on the InTune? If yes, what is the file number of the tune file?
Thanks

Thanks for the reply. Question: If you proceed with the tune after receiving the error notice (hit the Red 'X'), are you still able to restore the ECM to its original tune later?

I double-checked the updates (see picture). The steps I used are:
1) Ignition off;
2) Plug the I1000 into OBD port;
3) I1000 boots-up;
4) I1000 screen asks to turn-on accessories;
5) I1000 screen asks to turn car on without starting the motor;
6) I push car ignition button with my foot off of brake ...

After uploaded my I1000 with the latest software, I tried to tune the Z06. The InTune device appeared to recognize the car but when I tried to tune the vehicle I received an error message that the I1000 could not backup the OEM tune.
I tried emailing the support team but the form would not submit ...