Can I use my i3 to pull timing for my NX 100 shot? I'm using 93 octane and want to start with about a 4 degree retard in timing.
Any suggestions are welcome.

Thank you Sir!
I know since the truck has two fans, one electric and one mechanical.
Installing V6 fan and replacing both stock fans. The V6 fan will run with the A/C. Factory electric fan doubled as a secondary fan for engine cooling when needed. The V6 fan will run constantly with the A/C on. With ...

BUMP

Adding to Magnaflow exhaust with K&N cold air intake. What should I tweek?

I'm doing the electric fan conversion on my 2012 Ram Sport.
I'm leaving the stock I believe is 205 deg. Thermostat.
What should I set the fan on/off temps too?

Did update, been a while. took a bit of time, lots of updates. Connected to the truck i3 said calibration update needed so :-? reconnected to pc. downloaded update and reconnected to truck. now gives access to trans shift points 8) I can now control shift points at different throttle percentages ...

Did update, been a while. took a bit of time, lots of updates. Connected to the truck i3 said calibration update needed so :-? reconnected to pc. downloaded update and reconnected to truck. now gives access to trans shift points 8) I can now control shift points at different throttle percentages ...

Do all 6 speeds take a tune?
If not is there a way to tell if mine dose?
TCM doesn't show up just PCM. When I load a tune it changes the way it shifts.
I am not happy with the way it shifts with the tune. upshifts to quickly.

I am gonna take the truck to a performance transmission shop that we have in the area.
I talked to them over the phone just yesterday. The tech I talked with is very familiar with
this trans... and said he wanted to ohm-out the solenoid pack and check operating pressures.
He said that the tuner may ...

Well, tried that battery reset and no change.
Any other thoughts? Ideas? I really don't want to take it to the dealer.
We only use factory parts at work and that works great. Engineered
buy the designers. never a problem.

Nope, No codes. If I am correct the 2012 doesn't have a TCM the PCM controls the transmission with very little diagnostics.
I have access to the Dealer Connect software at work. the only stored code was drive side mirror heater open circuit.
I performed a transmission relearn procedure with no ...

I updated my i3 asper instructions when I removed it from the packaging.
I uploaded the 87 octane tune, turned off the MDS and set the throttle boost
to 20%. I ran the truck for about a month, transmission seemed to up shift to quickly.
I figured that maybe it was just skipping gears at part ...