So I installed my new spark plugs and wires and that was my problem the old wires were very brittle and I could feel the cores cracking and breaking with just a little force. I ended up having to destroy them just to get them out. The new wires and plugs cured every problem I had with the car. I ...

well if it's only around 4 at stock setting, then you adjusted the slope incorrectly then.. you made it way too rich... no need for you to be adjusting it THAT much....

I only went -4 on the slope and now the data logs were showing -17ltft. Im changing out my spark plugs and wires right now and ...

you have physical/mechanical issues with your car/mods if you're average ltft's are at -17 man...

you should be no where near that rich... so you have issues somewhere with that car...

check everything under the hood, make sure all vacuum lines, vent/breather hoses are connected where they ...

I have installed the 91 octane (because thats the highest grade gas available in my area), I have put over 75 miles on the car and I started data logging with my Intune in 5th gear 68mph 1900rpm and have ran those logs through the DSLogRedux program and its telling me to go -4 on my slope. The ...

Hey I decided to trade batterys with my other truck and it fixed the problem. Dont know what happened the first time I programmed it cause I followed the same procedures this time around and now there is a huge difference in power. My truck is AWD and now it makes a lil chirpin sound from the all ...

i disconnected the battery for a few minutes and the tried to start it but it still wont start.

I have the key in the run position when trying to restore.

when first tuned it I started the truck and drove around the block but i didn't feel a difference in power, the slp site says this tune should ...

I installed the tune on my truck and when i went to change the parameters it got the error message VIN NOT FOUND and it says the tune was not installed properly and to restore, when I try to restore it gets an "unknown error", Script error interpreter stopped, ERROR writing process terminated ...