Driving a 2010 Ram this morning... Short terms adding 33% and long terms subtracting 67%... This has gone on for 60 miles

Thank You... I look all over and never seem to find anything worth reading... This is good stuff....After reading am I (we) to assume the stock VE tables should be left alone and tune to injector slopes, Etc??????? If yes, is my Nueral Network disabled and where can I re- enable it??? Thank You in ...

OK, let me get this straight.. We are supposed to tune these trucks via the "Nueral Network" but this tune from RIPP has had zero mods to any tables in the Network............ Help me understand anybody

SAME DEAL MAN

ANYTHING OVER 3 OR 4 PERCENT THROTTLE INPUT PUTS IT INTO FAILSAFE MODE.KEY OFF, STARTS RIGHT BACK UP NOT IN FAILSAFE MODE BUT BARELY TOUCH THROTTLE AND INSTANTLY BACK INTO FAILSAFE

somebody want to SELL me a tune??????
Im only paying if it actually works
im soooo over this !@#$%^ Ford

e mailed and no response....I cant get it to not go instantly into failsafe mode unless i restore the stock tune....as it stands i have almost no mods to tune except injector high/low settings...tried 3 different cal files from the forums...tool is up to date, cant grasp why it was so far out of ...

GOT ONE HERE FORM THE LOCAL FORD DEALER...THEY FLASHED IT AND DELETED THE TUNE...SOLD THEM A I-1000...ANYBODY HAVE A CAL THAT WILL WORK ON THIS THING...BLUE GIANT INJECTORS, STOCK EVERYTHING ELSE....OBVIOUSLY THE BLOWER

ok, got everything dialed but still no READINESS...CANT GET THROUGH EMMISSIONS

8R36

WHEN I GO THROUGH THE DS DL IT DOESNT ASK ABOUT LAST TUNE WRITTEN OR THE 2 PRO CHARGER TUNES THAT ARE IN THERE.....IT ONLY GIVES ME THAT TUNE WHICH I POSTED..

OK, WHATS THE BEST WAY TO GET THE READINESS TESTS TO CLEAR???? GOT LONG TUBES WITH HI FLOWS..EVERYTHING PERFECT BUT IT WONT PASS READINESS TESTS, SO NO TAGS.......MARK

yeah 98kPa....seems i had the min baro voltage too high...lights off

anybody know what im missing here...2005 Jeep with a Ripp / Vortech supercharger, Blue Giant injectors, 2 Bar Map, etc.... runs fine otherwise...Thanks in advance...PS it hits the rev limiter at or just below 4000 RPM, i have it set to 6000......

got it on the dyno, cant get any of the readiness tests to go to "ready"..got the sheet from Mike L on how to do it, nothing is happening though....just want to be sure I didnt miss something in the tune