Try logging another ECU PID with AFR (e.g. Engine RPM).

IF I recall, Any SD card up to 2GB non-HC should work.

You need to have both BARO and MAP display the same units of measure. (e.g. kPa or inHg). The BARO reading of 29.44 sounds like inches of mercury (inHg).

On DV try File->Re Query Vehicle info while InTune attached to both PCM and PC/Laptop. May need to "double-click" the EXTERNAL sub tree in DV. Verify your using most current version of DV too.

This sounds like the max range for that PID. (I thought this sounded familiar. see http://diablosport.com/index.php?name=P ... highlight= )

See if there are other Speed PIDs in DV.

On DV try File->Re Query Vehicle info while Trinity is attached to both PCM and PC/Laptop. Might need to also "double-click" the External sub tree in DV.

Analog 1 & 2 should always show up in DV. IF AFR input were configured properly, it will also show up under External.

Do the following:
- Select Options->Analog Input Conf->Reset all to defaults
- Add A new Parameter
- Add "AFR" for Name
- Select channel
- Set Range upper and lower bound (I think ...

That explains why Analog 1 & 2 appear in DV but your AFR would not. DV is probably flagging it as an invalid input node from Trinity. Have fun!

You built a new parameter from Analog 1? No. You need to "add" a new parameter. Leave Analog 1 alone.

Try this 1st:
- Attach Trinity to PC/Laptop running DV.
- Verify it says connected on bottom bar and "lightning bolt is yellow" and Trinity says "under remote control".
- Select File->Re query ...

Those logs were taken with 1r08. Are you sure you updated your tool to 1r08b?

External means Trinity T1000 Analog inputs. Not USB devices.

You can try re-selecting the AFR input from your custom Trinity dashboard. But, IF you load the log file into DV (I agree EXTERNAL Inputs do not appear); And save DV's runtime.txt file found in "My Documents\DataViewer". When I loaded the log; runtime.txt was showing: "UNK IS NOT YET SUPPORTED ...

IF the Laptop has a 9pin "D" style connector, then use the U7777 kit
http://www.shopatron.com/products/produ ... /617.0.1.1?

Otherwise, the USB-Serial adapter U7778
http://www.shopatron.com/products/produ ... /617.0.1.1?

Do you mean you cannot select the AFR input in External Inputs section of DataViewer? (Your using 3.3.0.7 ?) Capture a short log on Trinity (with AFR on the Dashboard) and export using DataViewer. Post it here.

Keep in mind, any logs recorded with the previous analog configuration probably will not ...

NO. You need to reset Trinity analog configuration back to factory default. THEN add your AFR as a new input definition. Leave the default Analog 1 definition alone. Don't delete anything.

Trinity should then live stream using DV 3308.