I just want to Clarify that I am in no way saying that diablosport makes a bad product... I install the predators, and Powerpucks all day long with no issues what so ever... but this unit indeed seems like it was rushed to market. But I am sure the 2nd gen units will be great!!!

Well it was a cable issue... but after 3 Units that had screens that were shifted I sent them back... When i did mod the cable so that it did work it was ok.... At one point it loaded the map half way and then said to disconnect the battery and try again... after 4 hours of the truck not being able ...

Right there is the main reason I bought the Trinity over the edge... UPDATES!!!!

I think I have located the problem... the pins on my OBDII are a bit loose in the plug... I am going to re-pin them later and I think that should solve the issue.

can the boost setting be calibrated so it reads correct or am I stuck adding 14 all the time?

Truck ran like stock with the tow tune in there... I made sure the temp was over 170 and it was the same.... But the gauges would read like crap! 26 PSI at idle? I think this unit was Jacked to begin with.

Power is fine... worked after a reset of the batteries... but only for a little while.

Update... When unplug the batterys and let it sit for a bit... Hook everything back up... then it works again... for about 20 seconds then it all goes to hell again.

I am sending this one back and trying a new one. We'll see if that works

Just installed it today... worked ok... gauges were a bit erratic and read my boost at 26 at idle. Drove down the road and it all went to 0 and said that I needed to reconnect... so I did, and it didnt help. I hooked up my Matco scanner to the truck... now that wont even connect!!!!

What did the ...