Mike, Contacted tech support and they are sending out a new unit.

Thanx again

Mike, Thanx for the rapid reply.

Will get in contact later this AM.

Thanx again

My Trinity has started acting strange. Would change screens by itself then go to a PID setup screen then bump right back to the display. Would do this every couple of minutes.

Ran the updates last week and it seems to have corrected the erratic screen, but a new problem has shown up. After engine ...

Mike, Received replacement EX today. Thanx

Regrads
Bill Curtis

Called DiabloSport as instructed and they are immediately sending out a new tuner on an RMA. Excellent service, so far.

New Trinity EX is acting weird. Display screen switches views between the 3 available screens all by itself. If I reduce the touch sensitivity to a point it won't do it, the screen will not respond to actual touches. Sort of irritating.

2nd: per the picture included, the indicator on the upper left ...

On my '16 Ram, had to unbolt the PCM, roll it forward gently and numbers were on the back.

No need, it's a 2016

Update:

So, after typing the original post, took tuner back out to truck, plugged it back in and low and behold, it went right thru everything as it should. Swapped OEM PCM with the new unlocked one and did a 91 tune without a hitch.

Almost like it knew I was ratting it out. LOL.

Thanx any way ...

Just received my cross ship PCM last night and trying to start from the basics of getting the OEM configuration info prior to swapping the PCM's.

Tuner goes through the basic steps of turn to run yada yada yad, but fails to read OEM PCM configuration and goes into a reboot. This repeatable and can ...

Just received my cross ship PCM last night and trying to start from the basics of getting the OEM configuration info prior to swapping the PCM's.

Tuner goes through the basic steps of turn to run yada yada yad, but fails to read OEM PCM configuration and goes into a reboot. This repeatable and can ...

A program called AlfaOBD (used with a laptop or android phone) and a full function OBD reader like the OBDLink MX will make those changes.

The options are mostly stored in the BCM, not the PCM. Did them on my MY16 Ram 1500. Very easy, but be sure to do do a configuration backup before you start ...