Ok, thanks Mike and Monte, I'll go tune my truck again.

Not sure what happened here but I appreciate the guidance through it.

Somehow it is working now :D .

I hooked it up to power to pull the .xml you requested and noticed that instead of getting hung it started going through the install process. It completed the .itfg that was previously installed. I then run the updater again and it installed Diablo Master r155 (4 ...

Hi Mike, (and Monte),

I've gotten my i2030 into a slightly different state than before, but it still isn't working (or I'm not being patient enough).

Coming into today my device would power up (either via USB or OBD cable) and get stuck on a ":" screen.

I followed Monte's advice and reinstalled ...

I decided to dust off my i2030 and install the latest updates. I "unmarried" if from my truck just in case and then ran the Diablo updater. Somehow the process went wrong (or has changed) and now the Diablo updater is gone and I have an "Ignition" program installed on my computer and my i2030 won't ...

EDIT:

Thanks Johan, I'm good to go now.

To review, I needed the 9r27l (limited) CROM and the 05187901AH calibration file. Due to a combination of problems DSDownloader wouldn't automatically download that calibration. When I manually downloaded it and put it in place all was well.

Thanks again!

Johan,

Thanks for sending the crom file. I must still be doing something wrong because I can't figure out how to apply the tune.

To review:
The Predator with 9r12 says unsupported Calid.
Flashing the Predator to 9r27 gives a "no serial flash found" error.

You sent me 9r27l. That crom installs on ...

It looks like I am having this same problem.

I just purchased a used 2009 300C. I'm trying to update it with my Predator that was previously used on a 2006 Magnum (but it has been unmarried from that car).

The 2009 300C has Calid 05187901AE.

The Predator with 9r12 says that is an unsupported ...