no, it is telling you that your vehicle needs an update, since it has an older calibration.
It has no way to know that until you plug it into your truck and let it see whats going on there ;)

Ok, I did that and it asked me to register the intune...Can it later be restored to new (ie all that info ...

mikel wrote:after it says that, it asks you to connect to a PC and let it download an update for your Jeeps calibration, let it do that and your PCM will be supported

Shouldn't it have done that when it updated to 1r02a?
How many times do I have to update this thing???

Ok, so I hooked it up to my PC, walked away and let it run for quite a while. It seems to have updated completely a it now reads "Application: 1r02a" and everything under that says either "1r01x(*)" or "1r01x(ok)"...

After plugging it in to my truck it says "PCM calibration for (my VIN) is ...

if you go to settings , tool info. firmware the application should read 1r02a and the dbs under that should all say 1r0? they should not say missing. as chances are they are if you are getting vin db errors

Hmm, ok...It said it updated and to unplug but, my firmware reads "Application: 1r01i"

mikel wrote:plug it back into a PC, let the intune.exe run, and let it update everything

Plug it in again even though I plugged it in/updated as soon as I opened it and just before plugging it into my Jeep?

So I just got my new intune last night, updated it right away (after a few tries on my PC). Plugged it into my 2006 Jeep Grand Cherokee Overland which has the 5.7L HEMI, after following the instructions and tuning the key to ON I get a "VIN Validation Error" message. I've checke the Firmware info in ...