Board index General Technical Support DeltaChip ecm pins bent

ecm pins bent

DeltaChip Support

Moderator: mikel

Post Sat May 04, 2013 3:31 pm

Posts: 1
20130504_152804.jpg
20130504_152804.jpg (1.88 MiB) Viewed 8964 times
20130504_152808.jpg
20130504_152808.jpg (2.14 MiB) Viewed 8964 times
I recently bought a 96 mustang gt with a diablo chip already installed. My question is when I disconnected the harness, 2 of the ecm pins where bent. Was this a screw up when it was installed or was it done on purpose?

Post Mon May 06, 2013 3:55 pm

Posts: 55463
Location: DiabloSport World Headquarters

i cant imagine that being done on purpose...
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Return to DeltaChip