T1000 won't restore stock tune. Error code shown.

Post questions about your Trinity for your Dodge/Jeep/Chrysler vehicles here.

Moderator: mikel

Post Reply
MrMoe
Posts: 8
Joined: Wed Mar 25, 2009 3:28 pm

T1000 won't restore stock tune. Error code shown.

Post by MrMoe »

Trying to update my trinity T1000 firmware. Went to put my 07 jeep srt8 back to stock. It goes through the writing tune, gets too 100% then keep getting this error. First couple times I said yes return original tune when it didn't restore I unplugged the trinity tried to start my jeep and it would idle for a few seconds then shut off. After the third unsuccessful try I gave up. It stays on now but only with key in ignition. It won't stay running if I remote start out. Error im getting is. Now im getting a bunch of fuel level and ambient sensor error codes. It will drive but tries to shut down when stopped away a light or anything. So now it's just parked.
PCM: error unlock for reflash (-1)
User avatar
mikel
Posts: 57766
Joined: Tue Jan 16, 2007 1:17 pm
Location: DiabloSport World Headquarters
Contact:

Re: T1000 won't restore stock tune. Error code shown.

Post by mikel »

please give us a call with the device powered up in the vehicle.
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST

tech@diablosport.com
Post Reply