I have a in tune with the diablo tune set and I swapped the bcm with a salvage unit off eBay. I meant to load my original tune back on prior to the swap, but read bcm was not related to tunes done on the pcm, got in a hurry and just did the swap and the key cycling to have vats relearn. No problems , but a few months later I got a CEL and tried to make an adjustment for the tire size and it fails and the intune goes into recovery mode and asks to load stored tune. If I attempt to now read or load the factory tune, the intune now says there are no stored files for my vin. If I now try to load the diablo tune it reads what is on the truck, attempts to write new file, then fails and goes back to recovery; which I let it do.
Suggestions?
2003 Chevy Tahoe z71 BCM replaced now can’t adjust tune
- mikel
- Posts: 57793
- Joined: Tue Jan 16, 2007 1:17 pm
- Location: DiabloSport World Headquarters
- Contact:
Re: 2003 Chevy Tahoe z71 BCM replaced now can’t adjust tune
please post the current info.xml file from the intune drive, and anything from the tunes folder.
Thanks
Thanks
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST
tech@diablosport.com
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST
tech@diablosport.com