Board index Trinity 2 T2 for Dodge/Chrysler/Jeep/Ram Tried to restore factory settings. Now no crank

Tried to restore factory settings. Now no crank

This area of the forum is for discussions relating to the T2 monitor/tuner on Chrysler vehicles.

Moderator: sohfast94


Posts: 1
I have a 2012 challenger rt 5.7l

Tonight I tried to restore factory tune. Halfway through the on off cycle of Installing my tune. I accidentaly pressed the continue button when it said turn on run while key was off and after a few seconds it said tune failed to Install. Now tuner is stuck in a restore loop when plugged in to obd2. And security light blinks on dash. Car will do everything but start.


Posts: 56317
Location: DiabloSport World Headquarters

let it go through the recovery prompts to get it running, if not please call us with the tool powered up in the vehicle.


Thanks
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Return to T2 for Dodge/Chrysler/Jeep/Ram