Board index Trinity 2 T2 for Dodge/Chrysler/Jeep/Ram 2018 Charger OBD Gateway Bypass

2018 Charger OBD Gateway Bypass

This area of the forum is for discussions relating to the T2 monitor/tuner on Chrysler vehicles.

Moderator: sohfast94

Post Tue Jan 29, 2019 12:47 am

Posts: 2
Just picked up a T2 and PCM.

Going through the OBD gateway bypass instructions I can't find the Green connector bank on the Type B Installation.

Any tips on where this is? The picture on the instructions is not a 2018 charger.

Thanks

Post Thu Jan 31, 2019 11:20 am

Posts: 2
Same issue on 2018 Demon- only white block- plugging in the green connector does not work..

Post Thu Jan 31, 2019 12:29 pm

Posts: 2
Figured it out!! On the passenger side below the glove box, is the proper green port- just pop out a couple christmas tree pins and there it is- run the cable back over to the driver side OBD port and good to go- Remember to Thank Adam from Authentic Performance... i wasted an hour figuring this out...

20190131_122049.jpg
You do not have the required permissions to view the files attached to this post.

Post Thu Jan 31, 2019 12:38 pm

Posts: 56317
Location: DiabloSport World Headquarters

Sorry about that, we;re in the process of putting together some better documentation for these different locations across vehicles.
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST

Post Thu Jan 31, 2019 8:23 pm

Posts: 2
Thank you Adam! I was scratching my head.


Return to T2 for Dodge/Chrysler/Jeep/Ram