Board index Trinity 2 T2 for Dodge/Chrysler/Jeep/Ram Streaming to data viewer

Streaming to data viewer

This area of the forum is for discussions relating to the T2 monitor/tuner on Chrysler vehicles.

Moderator: sohfast94

Post Wed Mar 13, 2019 6:17 pm

Posts: 15
I had read online that we could stream data from our trinity 2 to data viewer but i can't get it to work it will never connect, any suggestions anybody? Seems like every custom tuner needs atleast 20 pid's but t2 can only do 16 pid's is there any fix or work around?

Post Wed Mar 13, 2019 9:33 pm

Posts: 15
Well instructions were incredibly wrong on how to stream data from a trinity 2 but i figured out the correct procedure to get it working and now i can data log with the data viewer.

Post Tue Mar 19, 2019 3:46 pm

Posts: 12
So crazybob, how did you get it to work? I'd like to do that.

Post Sun Mar 24, 2019 9:30 am

Posts: 15
My t2 might be messed up but here it is,
1. Have powered usb hub connection for laptop.
2. Leave t2 connected to obd2.
3.start vehicle.
4. Connect t2 via usb to laptop.
5.start ignition software and minimize
6.start data viewer and hit connect.
I had to vary the cable connection order sometimes but if the t2 goes into demo mode it never works right, sometimes I've had to have both obd2 and usb connected at the same time to start the process. It is very frustrating.

Post Wed Mar 27, 2019 3:21 pm

Posts: 12
Thanks crazybob


Return to T2 for Dodge/Chrysler/Jeep/Ram