Board index Trinity 2 T2 for Ford 2004 Ford Lightning Tuning Parameters

2004 Ford Lightning Tuning Parameters

This section of the forum is for discussion relating to the T2 tuner/monitor on Ford vehicles.

Moderator: sohfast94

Post Thu May 30, 2019 3:15 pm

Posts: 1
Hello,

I am thinking about buying the 9145 model for my truck. On the website, it shows these features:
  • 91 Octane Performance Tune: 35HP 40TQ
  • 93 Octane 2.81 Pulley Tune: 70HP 85TQ
  • 93 Octane 90 mm MAF Tune: 90HP 100TQ
  • 93 Octane 2.81 Pulley and 90 mm MAF Tune: 90HP 100TQ
  • 91 Octane 2.81 Pulley Tune: 45HP 50TQ
  • 91 Octane 90 mm MAF Tune: 45HP 50TQ
  • Touch Screen - Y
  • Data Logging - Y
  • Check Clear DTCs - Y
  • Accepts Custom Tunes from CMR - Y
  • Calibrate Speedometer for Gear Ratio - Y
  • Calibrate Speedo for Tire Size - Y
  • Fuel Rich/Lean Adjustment - Y
  • Spark Timing Advance/Retard - Y
  • Idle RPM - Y
  • Top Speed Limiter - Y
  • Rev Limiter - Y
  • Shift Points - Y
  • Shift Firmness - Y
  • Torque Management Adjustment - Y
  • Global Line Pressure Adjustment - Y

Does "Fuel Rich/Lean Adjustment" refer to closed loop tuning for affecting the TRIMs or does it refer to WOT enrichment? Is it a global modifier or are they RPM ranges where it can be adjusted?

Does "Spark Timing Advance/Retard" refer to global spark adjustment or are there RPM bands where it can be adjusted?

What is the granularity for adjusting the "Shift Points" and "Shift Firmness"?

Is there a MAF scaling option?

If I connect an external sensor to the unit using the EAS UNIVERSAL SENSOR INPUT kit, can that sensor data be included in the data logging?

I think the unit has a lot of potential, but I would like to know more before I pull the trigger and buy one.

Thanks,
Keith


Posts: 54867
Location: DiabloSport World Headquarters

Fueling adjustments are for WOT
Timing is WOT on the ranges and also a global option.
Shift points are 100 rpm increments, not exactly sure on pressure, as I think its % based.
No MAF scaling option.
EAS is not supported in Dataviewer for playback at the moment, but an update is in the works to allow that.


Thanks
Mike Litsch
Powerteq Customer Service Manager
Diablo Tech support by phone:
561-908-0040x4
M-F 8:00 AM to 5:00 PM EST


Return to T2 for Ford