Modify tune while NOT connected to car

slyder · Post by **slyder** » Sat Aug 22, 2009 10:02 pm

Can I connect the DSP to the wall adapter then adjust (modify) a tune while it is NOT connected to the car. Then go out and connect it to the car and install the map that I made changes too???

OR

Do I need this connected to the car 1st and then adjust the map??

-Slyder

Mike_Levy · Post by **Mike_Levy** » Sat Aug 22, 2009 10:06 pm

Unfortunetly it needs to be connected. I wish it didn't. Sitting in a hot car sucks.

Same with the Trinity and making gauge setups. Would prefer to do it on the computer and then upload it to the handheld, like MSD allows.

slyder · Post by **slyder** » Sun Aug 23, 2009 12:21 am

OOPPPSS

let me re-phrase, answer may be the same
Can I go into a tune, not connected to car, change a parameter (rev limiter example) then take it and load it into the car?

again may be the same answer just phrased better.

-Slyder

Cruisin1966 · Post by **Cruisin1966** » Sun Aug 23, 2009 12:22 am

No, you cannot. Something like that can only be accomplished while the Predator is connected to the car or if you have the CMR software

Mike_Levy · Post by **Mike_Levy** » Sun Aug 23, 2009 12:28 am

I actually took your first question to mean what you wrote in your second, so you really didn't have to rephrase. I knew what you meant.

Modify tune while NOT connected to car

Modify tune while NOT connected to car

RE: change tune while NOT connected to car