New PCM

baldyloxs · Post by **baldyloxs** » Tue Oct 13, 2009 7:31 pm

I reflashed my old PCM before my new one was installed,now it says its not supported? my new one has an AL after it what do I do ?
I need my CMR tune back in there,I Had to drive it home on a stock tune.

baldyloxs · Post by **baldyloxs** » Tue Oct 13, 2009 8:07 pm

Now I try to go to the latest crom update 19 from 9 my handheld incompatible hardware now it wont do anything it wont even connect to the DS DL . Email please
[email protected]

broadfca · Post by **broadfca** » Wed Oct 14, 2009 7:46 am

baldyloxs wrote:Now I try to go to the latest crom update 19 from 9 my handheld incompatible hardware now it wont do anything it wont even connect to the DS DL . Email please
[email protected]

This may or may not help, but this site gives loads of info about the U7135.

http://www.case-enterprises.com/xeryder ... edator.htm

Post by **mikel** » Wed Oct 14, 2009 9:52 am

baldyloxs wrote:Now I try to go to the latest crom update 19 from 9 my handheld incompatible hardware now it wont do anything it wont even connect to the DS DL . Email please
[email protected]

Load 9r12.

baldyloxs · Post by **baldyloxs** » Wed Oct 14, 2009 6:33 pm

LIke I said my DS DL cant find it now! It says CROM U7135-v.9t19e incompatible hardware.(No serial Flash Found) Contact Tech Support
So now what ? CAll you guys ? lol

Post by **mikel** » Thu Oct 15, 2009 9:44 am

There are explicit instructions for dealing with Legacy connect in the revision update instructions posted on each downloads page. Check em out..

baldyloxs · Post by **baldyloxs** » Thu Oct 15, 2009 4:35 pm

OK Bingo I got the tool loaded up with r12,SLaps Mike on the ass GOOD GAME thanks

New PCM

New PCM

RE: New PCM

Re: RE: New PCM

Re: RE: New PCM

RE: Re: RE: New PCM

RE: Re: RE: New PCM

RE: Re: RE: New PCM