TAHOE LT 2010

[redfoxsa]

Hi Folks

CAN i USE a Trinity with my 2010 TAHOE

and What kind of tune can be done with the T-1000

- Can i reset the shifting point for Six-Speed Transmission

Regards

[06MonteSS]

yes, you can use the trinity on that...

you'll have a Diablo Tune (for 91/93 octane gas), and an 87 octane tune...

no, you can not change any tranny parameters yet...

you CAN adjust:

COT time delay
#
DoD disable
#
Idle RPM Drive/Neutral
#
Injector Slope adjustment
#
WOT Fuel 2k-3.8k / 4k-4.9k / 5k-7k
#
Rev Limit
#
WOT Spark (in degrees) 1k-3.8k / 4k-5k / 5.2k-7k
#
Fan adjustment, individual adjustment per temp dependent cell
#
Tire Size
#
Speed limit(truck/SUV only)
#
Read/Write time is approx 60 seconds
#
Clear codes supported
#
Live data and log supported
#
Holds up to 5 custom tunes & Dat viewer is supported.

[redfoxsa]

- someone told me that i have to reprogram my car after i install the Exhaust cat-back ,
can i use the Trinity to do that and how , ( i have a magnaflow on my Tahoe )
also , if i add a ( volant ) cold air intake ... Do i have to reprogram or there is a special setting to get a maximum result ?

Thanks in advance

[06MonteSS]

do some data logging and get your fueling adjusted...

http://diablosport.com/index.php?name=P ... opic&t=917

[redfoxsa]

do some data logging and get your fueling adjusted...

http://diablosport.com/index.php?name=P ... opic&t=917

Thanks For Replay

i will waiting for my Trinity then i will back to you

Regards

[redfoxsa]

in my country they have a 91 and 95 octane fuel ,what should i use in the tuner ?

[06MonteSS]

95 octane gas in the truck...

diablo tune in the trinity...

[redfoxsa]

i install :
trinity_u7194-1r07a_update.crom
To my Trinity

but the only vehicle appear on Chevrolet 2010 is Camaro !!

How can i found my Car

[06MonteSS]

select 2009 tahoe....

it's the same truck, same tunes, etc etc

[redfoxsa]

Auto Connect is ENABLED.
Legacy Connect is DISABLED.
A tool was found on COM9 at 57600 baud.
XML RPC commands are AVAILABLE.
XML RPC protocol version is 1.60
Tool type = 'Trinity'.
Serial number = '6JSYXXX-1'.
Part number = 'u7194'.
CROM version = 'u7194-1r07a 02/18/2010 02:45:28 PM boot3'.
Vehicle VIN = '1GNUKBE0XAR100000'.
Vehicle Calibration = '12636005'.
Origional backup SAVED.
Tool is Married TRUE.
Single user tool FALSE.
Using Class2 Protocol FALSE.
Calibration Updates are NOT supported.
A Calibration Update is NOT required.
XML RPC WILL be used for FRG transfers.
Tune compression is AUTOMATIC.
Tune compression is set to ENABLED.
Tool registration is SUPPORTED.
Tool SUPPORTS multiple ECUs.
Config does NOT indicate multiple ECUs.
Tool reports 1 ECUs.

[redfoxsa]

Even With : trinity_u7194-1r07a_update.crom

i found Tahoe 2009 but i can not do any performance program or tune ??!