question on the cummins

bones · Post by **bones** » Mon Feb 26, 2007 5:07 pm

could you in the programming remove the P R N D 2 1 that appears in the gear selecter area,i believe this may eliminate tq management

Post by **mikel** » Mon Feb 26, 2007 6:10 pm

To remove TM you just need to disable it in the tool. Not sure how the gear selector would be an issue.

Thanks
Mike

ropnjessi · Post by **ropnjessi** » Tue Feb 27, 2007 12:31 pm

I think he could be refering to the Bully Dog, because when you turn off the TM for the high end P R N D 2 1 dissappears whereas on the low end power only they will still display....

johan · Post by **johan** » Tue Feb 27, 2007 7:32 pm

We have not had a chance to play around with the torque management in the Dodges yet. It might be a later venture as we need to jump on the 6.7L here shortly.

question on the cummins

question on the cummins

RE: question on the cummins