Corvette Z06 My 2009

[VETTESHARK]

Thanks Mikel, how can i do it?
Is for this reason that I have the messages "SERVICE ACTIVE HANDLING SYSTEM" , "SERVICE TRACTION SYSTEM" and on the display the logo of the engine malfunction?
Can I damage the car driving with the logo of the engine malfunction?
What do you advise me to do?

[mikel]

Those are normal after a reflash, aslong as they do not reappear it is fine.

[VETTESHARK]

..... but those error messages are always fixed on my display. Are you sure that I don't damage engine using the car?

[VETTESHARK]

Sorry, I forgot to say you that on my car are mounted:
1) Kooks long tube headers and x pipe cat
2) Killer Bee II air intake and Beehive (included with the intake)

[mikel]

They should not be there all the time....do they stay if you restore the stock tune?

[VETTESHARK]

Dear Mikel, as already written above I reinstalled Original Back-up = No change
Or rather, setting in motion the car (with Original Back-up installed) for the first few minutes don't show warning messages, but after about 15/20 minutes compare the same messages: "SERVICE ACTIVE HANDLING SYSTEM" , "SERVICE TRACTION SYSTEM" and on the display the logo of the engine malfunction.

I disconnected battery for 5 minutes = No change.

I want also note that before installing the Trinity I never had problems.

[mikel]

Is the trinity plugged in while this is happening?
Does it go away if you unplug the trinity?

[VETTESHARK]

Dear Mikel, the malfunction messages also appear when the Trinity is not connected. Yesterday I used the car in stock configuration, no tuning. After about 100 km is on the light engine fails. As I said my car mount collectors of Kooks long tubes, it's possible that the engine light comes on from the CO2 sensor? Do you think I can damage the engine if I continue to use the car?
Thanks for your help.

[06MonteSS]

yes, you are getting the trouble codes for the O2 sensors because of your headers...

[VETTESHARK]

But if I use the car , may the engine have some problems or can I ignore the engine light on the instruments panel?

[VETTESHARK]

up

[mikel]

you can ignore it if you like, it will not cause any issues.