u7136-9r07: predator screen went blank after writing tune??

[andyboydinomon]

I have a 2010 V6 Challenger and have used the 93oct tune for some time. I recently had a state inspection and servicing so I unmarried before I brought it in.

When I got the car back and went to put the tune back on:

It married and backed up the stock tune fine.

When I installed the 93 oct tune it wrote it to 100%; then it went to the turn key off turn key on screen; then it went to an hour glass; flickered a few times and shut off.(screen blank)

I unplugged and plugged it back in. I checked the last tune written and it was blank but it still had my car info on it (married).

I tried writing the tune again (it remembered my mods) and it did the same thing except it went to the PCM written ok to unplug screen instead of going blank. I never got the checking tune % meter that I think use to happen after you install a tune.

I later checked the last tune written and it shows the 93oct mod tune and my car info. Car runs fine and I can definitely tell the tune is on.

Should I be worried that something in the computer got messed up or is everything fine??? I have used the predator for over 8 months and this is the first time I notice it acting "fishy".

If a writing of a tune gets interrupted, could it completely kill the computer and I need to bring it to the dealer to fix it or could I just restore the back up tune?

[frankl]

Hmmm, Not sure what to say about the flickering in the tool. So the last tune written shows 93 perf? With Dodge vehicles, we can always force a back up, so there is no need to go to a dealer. Just keep an eye out next time you change tunes and if anything happens give us a call.