"exit called"

beam3215 · Post by **beam3215** » Tue Dec 27, 2011 9:54 am

while trying to enter into transmission parameters I get "exit called!" the inTune the freezes. What does this mean. I have to unplug to unfreeze it. I was trying to go from 91 CAI to modify stock tune, and need to know what axel ratio is set....I have 3.06 gears (not stock).......I cant get past this.

JonDiablosport · Post by **JonDiablosport** » Tue Dec 27, 2011 10:07 am

We are aware of this situation and we are working on it. Something got overlooked when a recent update was released. Normally this would be fixed however since it is the holidays It might take longer than expected due to the lack of staff this week.

beam3215 · Post by **beam3215** » Tue Dec 27, 2011 10:08 am

will my car go into limp.....

beam3215 · Post by **beam3215** » Tue Dec 27, 2011 10:10 am

need to know what to / not to do as I can't tell exactly what tune i am on

beam3215 · Post by **beam3215** » Tue Dec 27, 2011 12:11 pm

Spoke to Frank on the phone....I was able to check my parameters for the tranny (axel ratio) w/ my Predator....good thing I kept it...thanks. Let us know when you are able to fix the error w/ an update.

beam3215 · Post by **beam3215** » Tue Jan 03, 2012 9:53 am

Any scoop on the "fix"......? Thanx, guys.

beam3215 · Post by **beam3215** » Fri Jan 06, 2012 12:47 pm

any word...also w/ viewing data logging on the tool itself?

Post by **mikel** » Fri Jan 06, 2012 12:53 pm

was hoping to have it yesterday, will have it today for sure.

Nolimitzr1 · Post by **Nolimitzr1** » Fri Jan 06, 2012 1:10 pm

Not to be jerk will it be within next two hours? LOL

Post by **mikel** » Fri Jan 06, 2012 6:17 pm

Here is the fix, sorry for the delay.

beam3215 · Post by **beam3215** » Sat Jan 07, 2012 9:03 pm

Mike, I did the update, I think, correctly. I still get "exit called" on the gear ratio. Also, as stated in a difefrent thread, I no longer am able to get the InTune icon on the task bar, and I get device unrecognized due to device malfunction. Also I can't get data viewer to connect w/ the tool.

Post by **mikel** » Mon Jan 09, 2012 11:22 am

please post the info.xml file from your intune drive here or email it to me.

Thanks

Hewithnoname · Post by **Hewithnoname** » Mon Jan 09, 2012 9:28 pm

I have the same issue as beam. As far as the icon not showing up. Not in any hurry though Mike. You seem like you got your hands full and I plan on putting the car on the Dyno before I make any changes. I want to record any performance changes throughout all my mods.

"exit called"

"exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"

RE: "exit called"