Another Not Support Calibration Message

[AZ_Rider]

Hey Mike, I've got another PCM Calibration not support message and it's not allowing me to make any adjustments to the parameters, restore, or tune my truck. This time i've got 3 files that are in the "Tunes" folder and I don't know which one to send you. So i've just attached all 3! Please Help!

[mikel]

were you at the dealership since you last loaded the tune?

[AZ_Rider]

No, I just loaded up the 87 tune then looked around at some of the parameters. I did turn off the CAGS! I know that I shouldn't have though! Did I make a boo boo?

[mikel]

No, you can adjust anything you want, thats fine.
Did you notice the tool update since last time you flashed the truck?

[AZ_Rider]

Yes, I actually updated it yesterday.

[mikel]

so, after it updated, you went to the truck, and would not let you tune and it saved a new backup, correct?

[mikel]

can you post the info.xml file please?

[AZ_Rider]

I tried to tune it before the update and it gave me that error message and stated that it was unable to backup the PCM. Then I remembered that it was Thursday and updates were available, so I updated the inTune and tried it this morning to see if it would allow me to perform a tune, it gave me the same message again.

[AZ_Rider]

How do I pull up that file?

[AZ_Rider]

Nevermind dumb question!!

[AZ_Rider]

So what do you think Mike?

[mikel]

So what do you think Mike?

please drag this file to the intune drive, go back to the truck after it reboots and see if it lets you tune it.

[AZ_Rider]

Everything is back up and running! Thanks Mike!!