1r08k forced itself upon me, boost PID breaks...

[sota]

so 1r08k forced itself upon my trinity. today I noticed my boost guage was only going to 4.35psi huh?
checked the log... pratio is saying 2.5+ which is correct (about 22# boost.)

after much dickering around, clearing guages, reinstalling gauges, getting ready to do a WOT pull to 150 and tossing the trinity out the sunroof, I discover... it's NOW taking my max value as kPA instead of PSI like when I originally setup the gauges!

normally I create the gauge as follows...
add gauge
change to PSI
set lower (0) and upper (30) values

before that was fine.
no matter how I tried to create the gauge it always kept reading a max of 4.35PSI... and that was my clue. 4.35PSI == 30kPA!!! so I tossed an upper value of 200 in there and TADA!!! It's working again.

[mikel]

Interesting, I will report this bug.

[sota]

thanks.