Question on scan tool

BBrown88 · Post by **BBrown88** » Thu Mar 15, 2012 10:37 am

Got a question the scan tool for the intune, it says its reading two dtc's but it only shows one code. How do I look at the other one? Do I have to fix the first one, clear the codes the read it again or what? Happy with my tune on my truck but helping the family out with diagnosing their vehicles. Little confused with this.[/list]

Post by **mikel** » Thu Mar 15, 2012 11:39 am

what vehicle is it?
Its possible that it is a non 'P' code, which the tool may not display.

BBrown88 · Post by **BBrown88** » Thu Mar 15, 2012 3:04 pm

it's a chrysler van. I also tried it on a chrysler pacifica and it showed the same thing only 1 code

Post by **mikel** » Thu Mar 15, 2012 3:10 pm

could be using a different protocal that the vehicles we support.

Mike_Levy · Post by **Mike_Levy** » Thu Mar 15, 2012 3:13 pm

inTune is CAN-Bus only, right? The older Chryslers use the ISO-Bus.

Post by **mikel** » Thu Mar 15, 2012 3:45 pm

Nope, SRT4 are all SCI bus, not CAN

BBrown88 · Post by **BBrown88** » Thu Mar 15, 2012 5:24 pm

O okwell ill work around cuz its git to get fixed. I mean it only reads one code at a time. Idk I just fix one code and see how it goes from there.

Question on scan tool

Question on scan tool

RE: Question on scan tool

RE: Question on scan tool

RE: Question on scan tool

RE: Question on scan tool

RE: Question on scan tool

RE: Question on scan tool