2006 300C srt8 'service park assist' and eps light flashing

rconwa · Post by **rconwa** » Mon Apr 23, 2012 9:35 pm

I purchased my t1000 Friday. connected to my pc and installed 2.2.2.6 and updated the t1000 via usb. I connected it to my car and backed up the default tune. The 'service park assist' would display and the door chime would sound whenever I accessed a menu on the t1000. I loaded the 93 octane tune and upped my shift point. I followed the onscreen prompts and successfully wrote the new tune to the car. I did not drive it at that time. I drove it the next day and I noticed a big difference in the shift points and performance.
I tired to drive with the t1000 connected but the spedo wont register above 5 miles an hour, the 'service park assist' message flashes, the door chime goes off, the eps, brake and abs light flash every few seconds.
Any ideas?

Post by **mikel** » Tue Apr 24, 2012 10:25 am

new trinity?
cable in the back or bottom?

rconwa · Post by **rconwa** » Tue Apr 24, 2012 3:53 pm

Cable in the back

Purchased it new

rconwa · Post by **rconwa** » Tue Apr 24, 2012 8:34 pm

I didn't get the newest model, i take it?

Post by **mikel** » Wed Apr 25, 2012 11:36 am

thats the latest and greatest...

shoot me an email with your shipping info and we'll get a new cable out to you.

Thanks

mlitsch @ diablosport.com

rconwa · Post by **rconwa** » Wed Apr 25, 2012 4:10 pm

Just emailed you from my gmail account.
Thanks

Post by **mikel** » Wed Apr 25, 2012 5:30 pm

cable is on the way to you.

rconwa · Post by **rconwa** » Wed Apr 25, 2012 10:45 pm

Thanks!!

rconwa · Post by **rconwa** » Sun Apr 29, 2012 9:56 pm

I received the cable on Friday, Thanks again for the fast response. I have the same issue, unfortunately with the new cable.
Park assist error on the dash display, the park assist lights and chime sound, the brake light flashes every 30-40 seconds and the esp light stays on. Speedo will not register

Any other thoughts?

Post by **mikel** » Mon Apr 30, 2012 10:22 am

I need to do some investigating here...

rconwa · Post by **rconwa** » Thu May 10, 2012 6:32 pm

any update on this? Car wont run with trinity connected

rconwa · Post by **rconwa** » Fri May 18, 2012 9:31 am

Mike, should I rma this trinity for a replacement? is it a hardware issue or is there a way to reset it to factory and reload the software again?
Frustrating I can't use the trinity for monitoring
Thanks

MagRT · Post by **MagRT** » Sun May 20, 2012 6:20 pm

So this problem only affects '06 LX platforms? 'Cuz my trinity is slowly turning into a dash ornament now. As soon as I plug mine in, I hear chimes and vehicle (06 magnum rt) goes into limp mode.

rconwa · Post by **rconwa** » Tue May 22, 2012 10:08 pm

I saw the trinity in another 06 srt8, that's what prompted me to get one. Of course he had a bunch of engine work done and the trinity was installed by the techs who built his motor for him with custom tunes

Expensive frustration to say the least. I'm going to be driving to Orlando this weekend and would love to get some stats on the long drive.

Post by **mikel** » Wed May 23, 2012 11:22 am

Have you seen this thread?
http://www.diablosport.com/index.php?na ... 008#215008

it has all the answers !!!

it is an issue with a specific wire on the OBDII port, I am looking into being able to offer a new cable with PIN13 popped out, or, you could modify your existing OBDII cable to remove PIN 13 for now....

2006 300C srt8 'service park assist' and eps light flashing

2006 300C srt8 'service park assist' and eps light flashing

RE: 2006 300C srt8