Anyone want to play with TCM support?

BIGDADDY1969 · Post by **BIGDADDY1969** » Fri Jun 08, 2012 12:09 pm

..OK Mikel .... i'm on current version 1r02a ... ready for your TCM 4-speed auto (4l60e)
email ... [email protected]

BIGDADDY1969 · Post by **BIGDADDY1969** » Fri Jun 08, 2012 12:43 pm

BIGDADDY1969 · Post by **BIGDADDY1969** » Fri Jun 08, 2012 12:57 pm

bigdaddy_1969_1969@ yahoo.com for TCM ...

AZ_Rider · Post by **AZ_Rider** » Fri Jun 08, 2012 1:48 pm

Anyone else not being able to view TCM support on their InTune after software updated?

AZ_Rider · Post by **AZ_Rider** » Fri Jun 08, 2012 3:59 pm

Here's my info.xml file Mikel! Please sent me some TCM support!

BIGDADDY1969 · Post by **BIGDADDY1969** » Fri Jun 08, 2012 4:31 pm

TCM bump ... bumpity bump bump bump!!!!!!!!!! bigdaddy_1969_1969@ yahoo.com

AZ_Rider · Post by **AZ_Rider** » Fri Jun 08, 2012 4:41 pm

1969, message sent!

LGSONE · Post by **LGSONE** » Fri Jun 08, 2012 9:15 pm

Crap late to the party, Updated the intune, so I email what... yes I read the post... just need clarification please...

Oldsaltydog · Post by **Oldsaltydog** » Fri Jun 08, 2012 9:33 pm

Yup mines cooking with Tcm loaded hard shift tune this morning adjusted part throttle shift firmness still awesome
Never knew this would add so much to the drive ability factor and yp it squeals the tires on shifting at wot

Oldsaltydog · Post by **Oldsaltydog** » Sat Jun 09, 2012 3:22 pm

Great job diablosport although there was lots of grumbling about this it was well worth the wait in my opinion.
GREAT JOB GUYS

rthms20 · Post by **rthms20** » Sat Jun 09, 2012 5:37 pm

What you guys setting shift pressures and torque management at? Going negative on torque management reduces it right?

Oldsaltydog · Post by **Oldsaltydog** » Sat Jun 09, 2012 6:06 pm

Go into adjustable parameters firm or hard shift tune shift
It will show
Wot parameters and part throttle parameters
Firmer willbe negetaive towards leftsideof tool
Softer is positive towards right side of tool when changing settings I always reset all
Parameters

Oldsaltydog · Post by **Oldsaltydog** » Sat Jun 09, 2012 6:09 pm

Here is what I'm running on hard shift tune
Part throttle shift -4 all gears
Wot throttle shift -2 all gears
No banging into next gear so farim dialing up a littleata time till it bangs then I will back off and run those settings
When I get to that point

pilotj · Post by **pilotj** » Sun Jun 10, 2012 10:55 am

Can you send me the tune too??? Thanks!

grucela · Post by **grucela** » Sun Jun 10, 2012 12:00 pm

Mike,

Is the TCM support also for the 06 1500 GMC?