"Unable to find calibration update" error

[Curtlf]

Same problem. "Unable to find calibration update" error pops up. After that, it tells me to unplug the inTune and try again. I've unplugged it and tried a couple times and does the same thing.

[mikel]

what vehicle is it?

I see an 09 chally and maybe an 05 car as well?

[Curtlf]

09 CHALLENGER. Was data logging on 05 Magnum (not supported and wasn't intended to tune it)

[mikel]

oK< its asking for an update for the 05 model, what happens if you try to tune the 09?

[Curtlf]

It works fine when I tune the 09, backs up stock tune and writes the new tune. I have returned to stock for now but still wouldn't update. Should I remove the 05 or both from memory and retry?

Tried to delete 05 but not all of the 30 code digits fit.

[Curtlf]

Tried calling Tech support but after on hold for 30 minutes the costs were piling on. Any help on this ????

[mikel]

so, you dont need a cal update at all?

the tool is up to date...you dont need anything....

[Curtlf]

So what do I do about the error message? How do I delete the 05? What happens when I need an update?
Shouldn't the Intune tell me that it's up to date instead of error unable to find calibration update?

[mikel]

it wont check for a cal update unless the tool itself is up to date, all good.

[Curtlf]

OK thanx.

[Mwtaylor]

Is this something that happens every time. I just punches one and try to install today. 01/4/13. And my PCM shows error accrues in intunes. 2010 challenger Rt. cai with delta 40s

[mikel]

Is this something that happens every time. I just punches one and try to install today. 01/4/13. And my PCM shows error accrues in intunes. 2010 challenger Rt. cai with delta 40s

what is the error message?

[Mwtaylor]

While checking for updates error# 12029

[mikel]

thats usually a firewall error...is that a possibility?
can you try disabling the firewall?

[Mwtaylor]

Same error has occurred when firewall off. It always states that Intune update has stopped working. Not sure what is going on. Also I read in handbook something bout Belkin USB port or something. Well my wireless is Belkin. Do u think that is a problem