3.6L Pentastar Tuning

[stylish313]

So an update has been issued for the 3.6L Pentastar right? That news prompted me to rush and purchase a new Trinity which I've registered but cannot update because:

1. It says it has a tune already(I guess it's talking about the Demo tune?)
2. Says I need a code?
3. And the 2011 3.6L isn't already on the device.

Right now I'm stone-walled. I was hoping for some quick advice if possible.

[Mike_Levy]

Did you let it take a backup? If you did it won't work until thats off the unit. Also, change the vehicle type. It can't be on DEMO. Then plug it in and open DSDL and it should update itself.

[stylish313]

Did you let it take a backup? If you did it won't work until thats off the unit. Also, change the vehicle type. It can't be on DEMO. Then plug it in and open DSDL and it should update itself.

I played with it on my desktop in performance mode, didn't think that would bother it.

Most importantly, the 2011 3.6L isn't preloaded, so when I go to select my Chrysler 2011 only the Jeeps and trucks are my options.

[stylish313]

Update: Tune-Installed!

Most of my issues were operator error, not Diablo's. Although their video's seem to be a bit out of date, their tech support team were spot on.

Loved the difference in performance. I filled up the tank with BP 93 Octane, and the 3.6L never felt so good

[mikel]

glad to hear it

[stylish313]

Question. Is there anything I need to do when disconnecting my negative terminal after already installing a tune?

How about adding to my performance with a Borla Exhaust after having already tuning my ride?