I have a 2012 Dodge Charger SRT8 Super Bee and now an I Tune DCX. I connected to computer and it said it was updated, i checked and it has the 1r03x then below for dcx it shows 1r01. i connected to OBD2 3 times and 3 times I get:
"PCM Calibration for (VIN) might need an update. Check for Calibration Update?"
So i close screen and get "This vehicle is not supported, Contact DiabloSport."
My question is, What in the world do I need to do in order for this to work?
In Tune Calibration????
-
jerseymike
- Posts: 15
- Joined: Sun Nov 24, 2013 12:34 pm
Re: In Tune Calibration????
From what I have read you need to go back to your PC and let the Intune update again after it has your car information. Just plug it back to the PC and it should auto update but if it doesnt you can click on the update in the intune image that pops up. It may take from 10 to 30 minutes so just let it do its thing. It took me several tries to get it updated.
-
dellagratti
- Posts: 18
- Joined: Mon Mar 22, 2010 9:23 pm
Re: In Tune Calibration????
Ive done that 3 times and and each time the Intune window opens and says "up to date" then closes and opens a web page asking me to register it, which ive done. I can never keep that window open at all. Btw when i registered it i was sent a code, what do i do with that?
-
mikel
- Posts: 58782
- Joined: Tue Jan 16, 2007 1:17 pm
- Location: DiabloSport World Headquarters
- Contact:
Re: In Tune Calibration????
enter that code on the reg form to complete the process...
Mike Litsch
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST
[email protected]
DiabloSport Brand Manager
Diablo Tech support by phone:
561-908-0040
M-F 8:00 AM to 5:00 PM EST
[email protected]
-
dellagratti
- Posts: 18
- Joined: Mon Mar 22, 2010 9:23 pm
Re: In Tune Calibration????
Where?mikel wrote:enter that code on the reg form to complete the process...
