InTune freezes when trying to datalog

Crazyced · Post by **Crazyced** » Wed Aug 20, 2014 1:04 pm

I have an N-SRT-4 and I use the InTune to datalog with an analog input (wideband). Problem is that after the 1st log is done and saved, if I try to log another one, it will freeze while loading the PIDs. Then I have to cut power to reboot and try again. Sometimes it will freeze again the 2nd time.

Has anyone else notice this? This never happened before the update to log the analog inputs was made.

Post by **mikel** » Wed Aug 20, 2014 4:35 pm

I have not seen that or heard it reported, we'll have to check it out.

Crazyced · Post by **Crazyced** » Mon Aug 25, 2014 10:17 am

It's quite easily repeatable, at least in my case. I'd say it happens about 50% of the time.

Crazyced · Post by **Crazyced** » Mon Nov 10, 2014 6:35 pm

Any news on this? I would love it if I could datalog reliably.

Crazyced · Post by **Crazyced** » Tue Feb 17, 2015 12:27 pm

Bump, were you guys able to reproduce the problem?

I had done a little poll on the SRT forum a while ago.
http://www.srtforums.com/forums/f384/in ... og-710474/

2004 Dakota · Post by **2004 Dakota** » Wed Feb 18, 2015 5:15 pm

Mine also does this.

InTune freezes when trying to datalog

InTune freezes when trying to datalog

Re: InTune freezes when trying to datalog

Re: InTune freezes when trying to datalog

Re: InTune freezes when trying to datalog

Re: InTune freezes when trying to datalog

Re: InTune freezes when trying to datalog