Can't marry new trinity to srt4, 93 tune already on pcm

[Toze]

2005 srt4, I bought a trinity a few months ago. I was running the 93 octane tune without any problems. I had to send the trinity in for repair that was covered by the warranty, because the screen didn't work I couldn't reset the vehicle. I ended up getting another trinity, now this one obviously doesn't have my original backup on it. Now the problem is I can't marry the new trinity because it knows there's already a diablo tune on the vehicle. I have my original backup saved on my pc but can't find a way to make this work. Help!!




Auto Connect is ENABLED.
Legacy Connect is DISABLED.
A tool was found on COM4 at 115200 baud.
XML RPC commands are AVAILABLE.
XML RPC protocol version is 1.60
Tool type = 'Trinity'.
Serial number = '6QOPCB1-4'.
Part number = 'dcx_gas'.
CROM version = 'dcx_gas-1r13h 01/22/2016 06:09:17 PM boot4'.
Vehicle VIN = ''.
Vehicle Calibration = ''.
Original backup NOT saved.
Tool is Married FALSE.
Single user tool FALSE.
Using Class2 Protocol FALSE.
Calibration Updates are SUPPORTED.
A Calibration Update is NOT required.
XML RPC WILL be used for FRG transfers.
Tune compression is AUTOMATIC.
Tune compression is set to ENABLED.
Tool registration is SUPPORTED.
Tool SUPPORTS multiple ECUs.
Tool reports 1 ECUs.
Multi ECU Backups : 0
Marriage VIN :
Tool ID :
Desc :
Multi ECU Tuning : 0
Server:

[mikel]

please give us a call with the tool powered up in the car so we can force it to update the vehicle with a factory program.

[Toze]

I contacted tech support and was able to resolve this by force calibration. Everything is working and the custom tune is back in. Thank you diablosport

[mikel]

good deal.