2011 Ram torque management

Post here with any questions specific to the use of the i2 on Chrysler vehicles.

Moderator: sohfast94

User avatar
sohfast94
Posts: 3512
Joined: Mon Jun 02, 2008 3:49 pm

Re: 2011 Ram torque management

Post by sohfast94 »

tlm47201 wrote:Mike, Loaded the tune provided.....torque management seems to be off or improved. Issue is no select on traction control, but not the end of the world. Had the 91 octane tune in it and above 30 it pulls hard and runs with my Mustang Gt to well over 110 mph. The tune you gave me pulls lots harder off idle....which is nice....doesn't seem to pull any harder above 30 than the 91, but not an issue. For some odd reason this truck since new has seemed to run exceptionally well, and has held well against trucks with better gears and tuners while mine was stock. Its kinda fun to pull up beside the young'uns in the 'hot' cars, and stay with em or leave em in the dust. Probably go back to the 87 or tow tune for now. Just kinda wondered if the tune you gave me was 91 or 93 octane.....my tuner never showed a 93 tune.
It was the 91 tune.
Insert Clever comment here...

Image

Please do not PM me as I rarely see the notifications.
Dimplesbut29
Posts: 1
Joined: Wed May 18, 2016 3:22 pm
Location: Россия
Contact:

2011 Ram torque management

Post by Dimplesbut29 »

Is there anything I should leave alone in the trans torque management? Tuning a 14 challenger with the a580 btw.

Now for the line pressure Im assuming to bump that I would adjust the ramp torque, any input is much appreciated.
Post Reply

Return to “i2/i3 for Dodge, Chrysler, Jeep and Ram”