PCM calibration error

[Cam Jones]

I keep getting this error after installing all the up dates to my intune. I just got it the other day does anyone know how to fix this? My car is a 2010 dodge challenger se

[mikel]

please post the info.xml file from the intune drive.

[adrianp89]

I am having the same issue - Here is my Info file. I have '13 Ram 1500. Hope I can have this taken care of today, been meaning to get this done for a few months now lol. Time is tight.

[mikel]

I am having the same issue - Here is my Info file. I have '13 Ram 1500. Hope I can have this taken care of today, been meaning to get this done for a few months now lol. Time is tight.

what is your issue?
this device is not requesting an update.

[adrianp89]

I am having the same issue - Here is my Info file. I have '13 Ram 1500. Hope I can have this taken care of today, been meaning to get this done for a few months now lol. Time is tight.

what is your issue?
this device is not requesting an update.

Same issue as above, PCM calibration. I have tried updating it with Parallels for Mac but it says the device is updated. I have also tried clearing All Updates on the InTune.

[mikel]

please post the info.xml file from the intune drive.

[adrianp89]

please post the info.xml file from the intune drive.

Hey Mike, the info.xml file is posted in the third post of this thread. Thank you for your help.

[mikel]

as mentioned, there was no request for an update in that file, Id like to see the current one from the tool please.

[adrianp89]

as mentioned, there was no request for an update in that file, Id like to see the current one from the tool please.

Sorry about that. I plugged the unit into the truck again until I got the error, and here is the current info file.

[willyjatc]

same issue here .. i have a 2013 ram 1500 5.7L. keep requiring calibration update but says there is no update available..XML file attached.

[willyjatc]

additionally when i hit the question mark it say no vehicle found. my truck is now disabled in the driveway and is my only means of transportation .....this all started after i went to install the stock tune (due to a dealer maintenance appt) and during the "applying" stage the i2 shut off/rebooted and then begin stating vehicle is not currently supported.... expeditious reply would be greatly appreciated.

[mikel]

as mentioned, there was no request for an update in that file, Id like to see the current one from the tool please.

Sorry about that. I plugged the unit into the truck again until I got the error, and here is the current info file.

the file you need is downloading properly, you just need to runt he updater again to get the file loaded to the tool then flash it to the truck then you can tune it.