torque source logging

[WildHorse]

firmware changes get moved through a test cycle, and don't get pushed live until everything they are testing is good, hopefully not long

Sweet cause this already happened .
https://www.youtube.com/watch?v=aDzM4F9Y2AM

[mikel]

I enjoy battling with (good) street tires.
Went 11.78 in my 20 GT on the Michelins, and squeezed a 10.98 out of my buddys Hellcat Chally on the same tires.
Makes it exciting

[WildHorse]

So has the tech team looked into it yet ?

[mikel]

So has the tech team looked into it yet ?

you asking about the display issue or adding the torque source stuff?
display issue is in a test build and fixed, not sure when it gets pushed live.
torque source pid additions are a process...

[WildHorse]

The display issue .

[WildHorse]

So has the tech team looked into it yet ?

you asking about the display issue or adding the torque source stuff?
display issue is in a test build and fixed, not sure when it gets pushed live.
torque source pid additions are a process...

So is the display issue live yet ? Mines constantly pulling fuel.
set it to 16% , display shows 20% . So dunno if its adding 16% or 20%.
Which is better than adding I suppose.

[mikel]

this should have been fixed, let me look into it.

[mikel]

I'll have an update next week (tomorrow?) to add all the torque source logging and about 1000 other DMRs to DV2 software.
too much to jam in the t2 itself, but you'll be able to stream it from the t2 to DV2 and see everything.

[mikel]

update the t2 and use latest DV2 to stream and you'll get it all