2005 F150 issue with no idle change after tune

[mikewells1974]

2005 F150 5.4L , 4x4 , bone stock

Purchased New i3 Platinum #8145 - Updated Ignition Software (on Windows) - SN: 202799123

No changes to idle RPMs after installing 87 DiabloTune.

Installed Advanced Tune / Modify Parameters / Set Idle to 650-700 RPMs in Neutral & Drive / Removed Speed Limiter

Tune seems to install correctly & back-up file created/exported. No error statements.

Tried to update again, none available..

Warm Idle remains at +/- 500 RPMs..

New Tuner.

Cleaned MAF & TB , checked & found no vacuum leaks / Idle re-learn process.

Been a headache so far..

Please Help !
Thank you !

[mikel]

can you attach the last tune written file from the tunes folder here so we can take a look at the file?

[mikewells1974]

Thank you for the help !

[mikel]

thanks we're checking it out.

[mikewells1974]

The last tune attempt was with the aftermarket head unit unplugged , had read where it may cause issues.
(I stated bone stock earlier , head unit & SWC are the only mods , both disconnected).

Would the KAM cause an issue?
Wondering if installing with the door open would be best , so to keep the KAM off during ignition switch cycles.

Thanks again for the help

[mikel]

the aftermarket radios are not often an issue on Fords, mostly early GM trucks.
KAM wont be an issue, but keeping the door open is always a good idea when flashing.

[mikewells1974]

Any updates on the issue?

Thanks

[mikel]

Yes, we confirmed the params are not working and the cal team is working on a fix, should be an update this week i hope

[mikewells1974]

Sounds great !

I really appreciate you guys.

Thanks again !

[mikewells1974]

Hey Mike. Any updates?

Is the issue with the tuner itself? Would a different tuner have the same issue?

I have another i3 Platinum 8145 still sealed in the box. (accidentally two were purchased..)

I started to try the other tuner a couple weeks ago, but did not want to break the seal.

Any info or help would be great.

Thanks.

[mikewells1974]

Hey Mike. Any updates?

Is the issue with the tuner itself? Would a different tuner have the same issue?

I have another i3 Platinum 8145 still sealed in the box. (accidentally two were purchased..)

I started to try the other tuner a couple weeks ago, but did not want to break the seal.

Any info or help would be great.

Thanks.

[mikel]

its a firmware issue, it will be fixed in an update.

[mikewells1974]

10-4

Didn't mean to double-post..

Thank you.

[mikewells1974]

Good day Mike.

Any update on the issue ?

Thanks.

[mikel]

confirming with the team.