new u1798 w/ disc and no computer connection under options

dondb · Post by **dondb** » Thu Jul 24, 2008 11:39 am

OK - THIS IS MY FAULT - CORRECTION!!

I recieved a small disc with drivers on it with my transformer and data cable i bought from autoanything(not my predator). I went to load the driver and my computer told me i already had that driver? My predetor does get taken over by my computer when i open data viewer.

Guys - sorry for the screw up and the concerns of one of your clients.

pawngod · Post by **pawngod** » Mon Jul 28, 2008 9:27 pm

hit escape a couple of times

pawngod · Post by **pawngod** » Mon Jul 28, 2008 9:28 pm

do you have e40 program installed?

CANUCKPREDATOR · Post by **CANUCKPREDATOR** » Mon Jul 28, 2008 11:20 pm

dondb wrote:OK - THIS IS MY FAULT - CORRECTION!!

I recieved a small disc with drivers on it with my transformer and data cable i bought from autoanything(not my predator). I went to load the driver and my computer told me i already had that driver? My predetor does get taken over by my computer when i open data viewer.

Guys - sorry for the screw up and the concerns of one of your clients.

You are wanting to use the Dataviewer for logging?

Let's make sure the correct steps are taken first, then we can try some more troubleshooting.
1. Vehicle started
2. Plug in Predator
3. Start Dataviewer
4. Connect cable to computer
5. Wait a moment while computer and cable talk to each other (assuming drivers are installed and working correctly)
6. connect Predator and cable

Does dataviewer poll the Predator for vehicle information? It will say on the computer screen.

Post by **06MonteSS** » Mon Jul 28, 2008 11:26 pm

hey Canuck... how's this sound...

http://www.eprowebdesigns.com/06MonteSS ... onteSS.avi

CANUCKPREDATOR · Post by **CANUCKPREDATOR** » Mon Jul 28, 2008 11:57 pm

Ok, just needs to rev beyond 1500 rpm though. Let the inner beast become the outer beast. I'm wanting to do some exhaust work, but waiting for the funding to arrive from the finance department.