Problems with U7137 on 2008 Dodge Ram

00pumpkin · Post by **00pumpkin** » Mon Nov 24, 2008 10:01 am

I got a predator recently and plugged it up to my 08 hemi ram and it stated that there might be an update available and it couldnt connect. So I went and uploaded the lastest revision and tried hooking it up to my truck again and it gave me the same message as before. I ran a test and it was hooking up to the OBDII port fine. Can you please help me out on this?

Post by **mikel** » Mon Nov 24, 2008 11:44 am

It wants you to go to diablosport.com/dcx and do the calibration update, not the crom update.

00pumpkin · Post by **00pumpkin** » Mon Nov 24, 2008 12:06 pm

Oh, I didnt see anything in the manual that talked about the calibration update. Maybe I didnt look hard enough. Ill try that when I get home. Thanks.

00pumpkin · Post by **00pumpkin** » Mon Dec 01, 2008 11:43 am

It not say that I needed a calibration update in the DS downloader (no tab appeared). It still says that an update might be required and it gave me this # 05094504AH. Please Help!

johan · Post by **johan** » Mon Dec 01, 2008 12:00 pm

Thats one of the new 08 calids that we do not support quite yet, panning on adding it in this week.

00pumpkin · Post by **00pumpkin** » Wed Dec 03, 2008 3:15 pm

Where are you guys at on this??? Hopefully it comes before the weekend. Ive had this thing for over 2 weeks and its still not installed!!!

Problems with U7137 on 2008 Dodge Ram

Problems with U7137 on 2008 Dodge Ram

RE: Problems with U7137 on 2008 Dodge Ram